Home

What's hot

• Reduces heat buildup inside the cab and shades the rear of the vehicle from the glaring sun
• Custom molded of smoke acrylic for OEM windows
• Installs with strong automotive tape

• Set of 10 LED light No-polarity design, free of wrongly installation
• Standard Festoon base with 31/36/42mm for direct replacement
• Built-in power management for top brightness and reliability at the same time

• Helps to cut down on outside wind noise
• Clip-On Sunroof Wind Deflector - Made in USA!
• Easy to install- 1. Open the sunroof 2. Place sunroof wind deflector in front of opening with curved side facing back. 3. Center deflector (If you can't determine the center, place a small piece of masking tape along sunroof front opening just out of the way and measure for center and mark it with a pencil, and also find the center of the deflector using the same method this will allow you to align for proper alignment for installation.) 4. TEMPORARILY tape the clips to the sunroof flange (lip or trim ring that you will find in OEM factory-installed sunroofs). 5. Put one screw thru the hole in the deflector and on into the hole in the top of the clip. You will have to exert quite a bit of pressure on the deflector to get the screw to feed thru the hole this is entirely normal. 6. Screw thumbnut from below and slowly tighten, allowing the open end of clip to clamp on lower edge of sunroof opening. 7. Repeat steps on other side, but you should tighten each side just a little as you go and keep deflector centered.

• Clip-On Sunroof Wind Deflector - Made in USA!
• Only fits model with an OEM factory-installed sunroof
• Easy to install- 1. Open the sunroof 2. Place sunroof wind deflector in front of opening with curved side facing back. 3. Center deflector (If you can't determine the center, place a small piece of masking tape along sunroof front opening just out of the way and measure for center and mark it with a pencil, and also find the center of the deflector using the same method this will allow you to align for proper alignment for installation.) 4. TEMPORARILY tape the clips to the sunroof flange (lip or trim ring that you will find in OEM factory-installed sunroofs). 5. Put one screw thru the hole in the deflector and on into the hole in the top of the clip. You will have to exert quite a bit of pressure on the deflector to get the screw to feed thru the hole this is entirely normal. 6. Screw thumbnut from below and slowly tighten, allowing the open end of clip to clamp on lower edge of sunroof opening. 7. Repeat steps on other side, but you should tighten each side just a little as you go and keep deflector centered.

• Hardware included
• Easy to install
• No driling or tape required